Epson 50 - Artisan 50 - Printer, Руководство по обслуживанию

Страница: 28 / 129

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 2 Operating Principles 2.4 Printer Initialization 28
Confidential
Note *1: The rotation direction of the PF Motor is as follows.
Clockwise: Paper is fed normally
Counterclockwise: Paper is fed backward
*2: The condition of the CR lock is as follows.
Red: CR lock is set
White: CR lock is released
*3: Indicates the PG position. “Any position” means that the PG position is not
recognized because APG is not reset yet.
*4: Checks if the carriage is not deadlock such as the CR lock is caught in the gap of the carriage.
*5: Eject the paper if any.
*6: When paper exists, the existing measurement value saved in EEPROM is read out;
therefore, the PF Motor does not rotate.
*7: Executes when the detected temperature is under 5
o
C (41
o
F) by the thermistor on the Printhead.
*8: The empty sanction operation may occur depending on the situation.
*9:
If paper remains in the printer, the PF Roller rotates by steps enough to eject the paper forcibly.
2.4 Printer Initialization
There are four kinds of initialization method, and the following explains each
initialization
1. Hardware initialization
This printer is initialized when turning the printer power on, or printer recognized
the cold-reset command (remote RS command).
When printer is initialized, the following actions are performed.
(a) Initializes printer mechanism
(b) Clears input data buffer
(c) Clears print buffer
(d) Sets default values
2. Operator initialization
Initialization when resetting the USB software, and the following are performed.
(a) Clears input data buffer
(b) Clears print buffer
(c) Sets default values
3. Software initialization
The ESC@ command also initialize the printer.
When printer is initialized, the following actions are performed.
(a) Clears print buffer
(b) Sets default values
4. IEEE 1284.4 “rs” command initialization
The printer recognized the IEEE 1284.4 “rs” command.
When printer is initialized, the following action is performed.
„ Initialization when an error occurs.
(a) Initializes printer mechanism
(b) Clears input data buffer
(c) Clears print buffer
(d) Sets default values
„ Initialization in normal operation
(a) Clears input data buffer
(b) Clears print buffer
(c) Sets default values
13.Detecting ink cartridge and initializing ink system
*8
13-1.The PF motor rotates clockwise and releases the
CR lock.
↓
13-2.The PF Motor rotates clockwise for one second,
and resets the PF Roller.
*9
↓
13-3.The carriage slowly moves to the 0-digit side.
PG--
13-4.After the carriage moves to the 80-digit side and
checks the ink end sensor, detects the ink
remaining. ↓
13-5.The carriage slowly returns to its home position.
↓
14.CR lock setting
14-1.The carriage slowly moves to the CR lock set
position.
↓
14-2.The PF Motor rotates counterclockwise, and sets
the CR lock. ↓
14-3.The carriage slowly returns to its home position.
↓
Table 2-5. Operation of the power-on sequence
Operation
*1
Carriage/PF roller
movement and position *2
PG
*3