Emerson Avocent AutoView 2108, Инструкция по установке и эксплуатации

Страница: 41 / 72

OBWI Operation ..... 35
Network Settings
NOTE: Only administrators can make changes to the Network dialog box settings. Other users will have
view only access.
From the side navigation bar, click Network to display the General, IPv4, and IPv6 tabs.
To configure general network settings:
1. Click the Network tab, then click the General tab to display the switch General Network Settings
screen.
2. Select one of the following options from the LAN Speed drop-down menu: Auto-Detect , 10 Mbps Half
Duplex , 10 Mbps Full Duplex , 100 Mbps Half Duplex , or 100 Mbps Full Duplex .
NOTE: You must reboot if you change the Ethernet mode.
3. Select either Enabled or Disabled in the ICMP Ping Reply drop-down menu.
4. Verify or modify the HTTP or HTTPS ports. The settings will default to HTTP 80 and HTTPS 443.
5. Click Save .
To configure IPv4 network settings:
1. Click the Network tab, then click the Address tab to display the IPv4 Settings screen.
2. Click the IPv4 button.
3. Click to fill or clear the Enable IPv4 checkbox.
4. Enter the desired information in the Address, Subnet, and Gateway fields. IPv4 addresses are entered
as the xxx.xxx.xxx.xxx dot notation.
5. Select either Enabled or Disabled from the DHCP drop-down menu.
NOTE: If you enable DHCP, any information that you enter in the Address, Subnet, and Gateway fields will
be ignored.
6. Click Save .
To configure IPv6 network settings:
1. Click the IPv6 button.
2. Enter the desired information in the Address, Subnet, and Prefix Length fields. IPv6 addresses are
entered as the FD00:172:12:0:0:0:0:33 or abbreviated FD00:172:12::33 hex notation.
3. Select either Enabled or Disabled from the DHCP drop-down menu.
NOTE: If you enable DHCPv6, any information that you enter in the Address, Gateway, and Prefix length
fields will be ignored.
4. Click Save .