elsner elektronik KNX AQS TH-B-UP, Установка и настройка

Страница: 53 / 56

52 Parameter setting
Sensor KNX AQS/TH-B-UP • as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
Shutter, blind, awning or window control:
if you want to actuate a drive using a pushbutton, select the "shutter", "awning",
"blind", or "window" function and define the pushbutton function and control mode.
* For further details about settings, please see

Control modes for drive control , page
53
Dimmer:
If the pushbutton should be used as a dimmer, select the function "Dimmer" and define
the pushbutton function, time interval (switching/dimming) and if required, the repeat
interval for extended pressing of the pushbutton.
8 bit encoder:
If a fixed 8-bit value should be sent using the pushbutton, select the "8-bit encoder"
function and define the value to be sent
Function Changeover switching
Command when pressing the pushbutton • Changeover switching
• Do not send message
Command when releasing the pushbutton • Changeover switching
• Do not send message
Function Shutter/blind/awning/window
Pushbutton function Up • Down
Up • Down • Up/Down
On • Off • On/Off
Open • Close • Open/
Close (Shutter)
(Blind)
(Awning)
(Window)
Control mode* • Standard
• Standard inverted
• Comfort mode
• Dead man’s switch
Bus function Dimmer
Pushbutton function Brighter • darker • Brighter/darker
Time between switching and dimming
in 0.1 seconds 1...50; 5
Repetition of the dimming command no • yes
Repetition of the dimming command
upon extended button actuation
(only if dimmer command is repeated)
every 0.1 s... • every 2 s; every 1 s
Dimming by
(only if dimmer command is repeated)
1.50% • 3% • 6% • 12,50% • 25% • 50%