elsner elektronik KNX AQS TH-B-UP, Установка и настройка

Страница: 50 / 56

49 Parameter setting
Sensor KNX AQS/TH-B-UP • as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
When switching from the two- or three line value display to the thermostat display, the
display duration can also be set and return approved/blocked by means of an object.
If Values (two or three lines) are displayed, the contents of the lines must be defined
and where required, the input objects activated for external values.
Temperature controller display when using
pushbutton
(only possible if the pushbuttons are also
set to "For temperature control")
No • Yes
Type of temperature target value display
(only for active thermostat display)
• Current target value
• Basic setpoint
• Basic setpoint as bar chart
• Basic setpoint as bar chart with count
• Basic setpoint as bar chart with range
• Basic setpoint as bar chart with range and
count
(see also Display and operation at the
device , page 10)
Display duration in seconds for
Temperature controller display
(only for thermostat display
after pressing a pushbutton)
2...240; 5
Use object "Return approval"
(only for thermostat display
after pressing a pushbutton)
No • Yes
Object evaluation
(only if Return approval object
is used)
• 1= Allow return | 0=Return not allowed
• 1= Allow return | 0=Return not allowed
Object value prior to initial communica-
tion
(only if object Return approval
is used)
1 • 0