elsner elektronik KNX AQS TH-B-UP, Установка и настройка

Страница: 45 / 56

44 Parameter setting
Sensor KNX AQS/TH-B-UP • as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
5.12. Logic
Activate the logic inputs and assign object values up to 1st communication. Then, ac-
tivate the required logic outputs.
AND logic
OR logic
5.12.1. AND and/or OR logic 1/2/3/4/5/6/7/8
AND- and OR logic gates provide the same setting options. Assign the inputs to a
switching event and set the send behaviour.
If the logic output sends one 1-bit object:
If the logic output sends two 8-bit objects:
Use logic inputs No • Yes
Object value prior to 1. communication for:
Logic input 1... 16 0 • 1
Logic 1/2/3/4/5/6/7/8 not active • active
Logic 1/2/3/4/5/6/7/8 not active • active
1. / 2. / 3. / 4. Input • do not use
• all switching events which are available
to the sensor (siehe AND logic connection
inputs , Seite 46)“)
Logic output sends • one 1-bit object • two 8-bit objects
Logic output sends one 1 bit object
if logic = 1

object value 1 • 0
if logic = 0

object value 0 • 1
Logic output sends two 8 bit objects
Type of objects • Value (0 ... 255)
• Percent (0% ... 100%)
• Angle (0°... 360°)
• Scenario load (0 ... 127)
if logic = 1

object A value Setting dependent on "type of object"
if logic = 0

object A value Setting dependent on "type of object"
if logic = 1

object B value Setting dependent on "type of object"
if logic = 0

object B value Setting dependent on "type of object"