elsner elektronik KNX AQS TH-B-UP, Установка и настройка

Страница: 42 / 56

41 Parameter setting
Sensor KNX AQS/TH-B-UP • as of software 3.1 • Version: 01.03.2017 • Technical changes and errors excepted.
General control
The Sensor KNX AQS/TH-B-UP can be used to control one or two-stage ventilation.
Configure a block for the ventilation control using the blocking object.
Determine when the current control settings are to be sent to the bus. Periodic trans-
mission is safer if a message does not reach a recipient. You may also set up periodic
monitoring using an actuator with this setting.
The status object shows the current status of the output variable (0 = OFF,
>0 = ON) and can for example be used for visualisation.
Controller target value
The target values can be set directly in the application program using parameters, or
be defined via the bus using a communications object.
Target value setting using parameter:
Set the target value directly.
Setting a target value via communications object:
Enter how the target value will be received from the bus in advance. Basically, a new
value can be received, or simply a command to increase or decrease.
Type of control • One-stage ventilation
• Two-stage ventilation
Behaviour of the blocking object with value • 1 = Block | 0 = release
• 0 = block | 1 = release
Blocking object value
before 1st communication 0 • 1
Actuating variable comparator • on change
• on change and periodically
Send cycle
(
is only sent if "periodically" is selected)
5 s • ... • 5 min • … • 2 h
Send status object(s) • on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
Send cycle
(
is only sent if "periodically" is selected)
5 s • ... • 5 min • … • 2 h
Target value setpoint using Parameter • Communications object
Target value in ppm 400…5000; 800