Eliet Minor 4S, Руководство пользователя, Страница: 45 / 58

A A B
English
45
11.5.6.1 Work method for reversing the blades
Warning:
Wear protective gloves – the blades are razor sharp!
• Remove the spark plug cable as a precaution.
• As for grinding the blades, the machine is placed on its front foot and the handlebar. Beware of
petrol leakage from the reservoir.
• Remove the sealing plate. To do this, loosen the star screw. This
will give better access to the shredding chamber.
For your information:
Remove and refit one blade at a time. This ensures that reversal is performed in
an orderly manner.
• To disassemble the blades, loosen and remove the two (M8) bolts. Replace any damaged bolts.
Pull the blades loose with a grip wrench.
• Zone A: for the blades on the outermost blade discs, do the
following: Disassemble a blade from the left side; turn it 180°
and remount it in the same position on the right hand disc. The
blade from the right hand disc is rotated 180° and placed into
the vacated hole in the left hand disc. This procedure is repea-
ted until all the blades from zone A have been exchanged.
• One all the blades from zone A have been reversed, check again
that the bevelled edges point towards the centre of the shredding chamber, not towards the
wall plate. If this is not the case, then two blades were not reversed correctly.
• Zone B: for the blade discs which are enclosed between the discs of Zone A, do the following:
Disassemble the blades in Zone B; turn 180° and remount in the same position on the right
hand disc. The blade that must be disassembled for this purpose is rotated 180° and placed
in the vacated location on the blade axis. This procedure is repeated until all the blades have
been reversed (zone B according the illustration). After reversing all the blades from zone B,
the bevelled sides should be facing the axis. If not, the procedure was not carried out correctly
and must be remedied.