Eliet Minor 4S, Руководство пользователя, Страница: 44 / 58

7.5 kg
1 cm
English
44
• In order to check the exact belt tension, a weight of 7.5 kg
must be hung on the V-belt. If the belt sags 1 cm, the belt
tension is correct (see illustration).
• Adjust the belt by sliding the engine block forward.
To do this, the four M8 bolts on the engine base must be unscrewed (2 x ring spanner 13).
Loosen the (M10) bolt at the front of the engine block after having removed the lock nut. Via
the nut at the back of the engine, the engine block can now be moved forward.
• Before unscrewing the machine, using a felt-pen two points must be marked on the chassis
plate to both sides of the engine block. This will save time afterwards when lining up the
pulleys.
• The (M10) bolt at the back is tightened until the correct tension is obtained. The bolt is then
fastened with the lock nut.
• The two belt pulleys can now be lined up by screwing back
the bolt at the front of the engine. The pulleys are aligned
if a slat, held against the pulleys, touches the four indicated
points (see illustration).
CORRECT T CORRECT ALIGNMENT
=> LONG LIFE CYCLE OF THE BELT
• Once the correct tension and alignment have been achieved, the engine can be locked by
tightening the bolts (M8) (2 x ring spanner 13).
• Only after everything has been checked carefully can the protective cap be replaced in its
original position.
11.5.6 Reversing and changing chipper blades
Regular grinding of the blades provides a blade life of more than 50 hours per cutting edge. After
having used up a cutting edge, the blade can be reversed, providing another 50 hours. If both blade
edges are worn the entire blade must be replaced.
Caution:
The warranty shall not apply to damage or consequential damage caused by
inadequate maintenance of the blades. Consult your official ELIET dealer for
advice if required.