Eliet Minor 4S, Руководство пользователя, Страница: 27 / 58

English
27
• It is useless to feed too much material into the machine at once. Reducing the material volume
speeds up the entire process.
• When inserting branches, the thickest end of the branch will have to be introduced into the
feed hopper first.
• Preferably feed the branches into the right side of the hopper. That way the chips sit in the
shredding chamber for a longer period before being sucked towards the turbine. This also
ensures that the chips are smaller in size.
• In the event that the volume of leaves to processed is very large, ELIET recommends to
alternately shred leaves and branches.
• Cease operation immediately when you hear unfamiliar sounds. Stop the engine (emergency
stop bracket) and examine the cause of the sound. Perform any necessary repairs before
continuing.
• Should you notice that, despite all of the preparations made, a foreign object still has found its
way into the machine, the motor must be shut off immediately. Remove the foreign object and
check for damage. Any defects must be repaired before resuming operation.
• The engine should, in principle, shut down automatically when the shredding chamber is
opened. If it does not as a result of an electrical defect, the operator immediately must turn off
the engine manually and refrain from using the machine until it has been repaired.
• If the shredding chamber gets clogged up, switch off the machine to remove the blockage.
Make sure to wait for the blades to come to a complete standstill before carrying out any
operation on the machine.
9.6.3 After the engine stalls
Overloading, overfeeding, blockage of the discharge, fuel shortage, a closed fuel tap, insufficient
oil, the safety handle in the wrong position and improper closure of the shredding chamber
are all possible causes of a stalling engine. The chipper can be easily restarted in these cases.
Proceed as follows:
1. Check the petrol level in the tank (see § 9.2 Refuelling).
2. Remove all branches from the feed intake opening.
3. Briefly pull the starter cord to verify whether the blade axis is still blocked. As soon as you
feel resistance and are unable to pull the cord any further, simply release the cord. It is use-
less to pull the cord forcibly as this could cause it to break or overload the starter mecha-
nism.
4. If the blade axis is blocked, the shredder compartment
must be emptied. This requires opening of the shredding
chamber. The cover screen is attached at its top with a star
screw. Remove the star screw and lower the cover.