Eliet Minor 4S, Руководство пользователя, Страница: 35 / 58

English
35
11.3.2 What does cleaning entail?
Cleaning the machine implies a thorough check-up and inspection of the machine. Check that no
parts have been deformed, that welded seams are not cracked and that parts are not excessively
loose.
Important points include:
• Blade shaft welding seams.
• Bolts for blade attachment.
• Blade shaft retaining bolt.
• Turbine welding seams.
• Anti-projection flaps in feed hopper.
• The engine should be clear of dust and dirt. The cooling fins in particular as well as the area
around the exhaust must be clean. The area around the fuel cap must be kept clean to avoid
dirt entering the fuel tank.
• The bushings must be cleaned of sand and dirt that has become stuck in the lubricating
grease. Reapply lubricating grease after wiping the bushings.
Any necessary replacement and/or repair works must be undertaken immediately. Ask your
authorised ELIET dealer to carry out repairs (find an authorised ELIET dealer near you
www.
eliet.eu ).
Cleaning the machine involves more than just cleaning the outside. Open all protective covers so
that you can also clean the inside of your machine.
The following points require special attention:
• Dirt (chippings, wood residue, dust, sand, sticky leaves, etc.) accumulated inside the machine
must be removed. Use a soft brush or vacuum cleaner to remove this dirt.
• Fibre strands that have wrapped themselves around the blade shaft should be removed to
prevent them from damaging the bearing seals of the engine.
• Remove all accumulated sticky dirt inside the chipping chamber.
• Remove all accumulated sticky dirt inside the turbine and the blow chute.
Caution:
Always wear gloves when performing maintenance. You will be near the blades
when cleaning the chipping chamber and the turbine. The blades are razor-
sharp and therefore represent a real risk of cuts. Take care and try to avoid all
contact.