Electrolux 30" GAS FREESTANDING RANGES, Руководство по обслуживанию

Страница: 16 / 132

16
Before Starting - Tools You Will Need
For Leveling Legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock pliers
• 5/16" Nutdriver or Flat Head Screw Driver
• Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry
Drill Bit if installing in concrete)
For gas supply connection:
• Pipe wrench
For burner flame adjustment:
• Phillips head and
blade-type screwdrivers
For gas conversion (LP/Propane or Natural):
• Open end wrench - 1/2"
Additional Materials You Will Need:
• Gas line shut-off valve
• Pipe joint sealant that resists action of LP/Propane
gas
• A new flexible metal appliance conduit (1/2" NPT
x 3/4" or 1/2" I.D.) must be design certified by CSA
International. Because solid pipe restricts moving
the range we recommend using a new flexible
conduit (4 to 5 foot length) for each new installation
and additional reinstallations.
• Always use the (2) new flare union adapters (1/2"
NPT x 3/4" or 1/2" I.D.) supplied with the new
flexible appliance conduit for connection of the
range.
Normal Installation Steps:
1. Anti-Tip Bracket Installation Instructions
Important Safety Warning:
To reduce the risk of tipping of the range, the range must
be secured to the floor by a properly installed anti-tip
bracket and screws packed with the range. Failure to
install the anti-tip bracket will allow the range to tip over
if excessive weight is placed on an open door or if a child
climbs upon it. Serious injury might result from spilled
hot liquids or from the range itself.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Instructions are provided for installation in wood or
cement fastened to either the floor or wall. When
installed to the wall, make sure that screws completely
penetrate dry wall and are secured in wood or metal.
When fastening to the floor or wall, be sure that screws
do not penetrate electrical wiring or plumbing.
A. Locate the Bracket Using the Template - (Bracket
may be located on either the left or right side of the
range. Use the information below to locate the
bracket if template is not available). Mark the floor
or wall where left or right side of the range will be
located. If rear of range is against the wall or no
further than 1-1/4" from wall when installed, you
may use the wall or floor mount method. If molding
is installed and does not allow the bracket to fit
flush against the wall, remove molding or mount
bracket to the floor. For wall mount, locate the
bracket by placing the back edge of the template
against the rear wall and the side edge of template
on the mark made referencing the side of the
range. Place bracket on top of template and mark
location of the screw holes in wall. If rear of range
is further than 1-1/4" from the wall when installed,
attach bracket to the floor. For floor mount, locate
the bracket by placing back edge of the template
where the rear of the range will be located. Mark
the location of the screw holes, shown in template.
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket
is to be mounted to the wall, drill pilot hole at an
approximate 20° downward angle. If bracket is to be
mounted to masonry or ceramic floors, drill a 5/32"
pilot hole 1-3/4" deep. The screws provided may be
used in wood or concrete material. Use a 5/16" nut-
driver or flat head screwdriver to secure the bracket
in place.