Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 775 / 1116

Chapter 27
| IP Interface Commands
IPv6 Interface
– 775 –
ND advertised router lifetime is 1800 seconds
Console#
Related Commands
ipv6 nd ns-interval (775)
show ipv6 neighbors (780)
ipv6 nd ns-interval
This command configures the interval between transmitting IPv6 neighbor
solicitation messages on an interface. Use the
no form to restore the default value.
Syntax
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
milliseconds - The interval between transmitting IPv6 neighbor solicitation
messages. (Range: 1000-3600000)
Default Setting
1000 milliseconds is used for neighbor discovery operations
0 milliseconds is advertised in router advertisements
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
When a non-default value is configured, the specified interval is used both for
router advertisements and by the router itself.
◆
This command specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing the
reachability of a neighbor. Therefore, avoid using very short intervals for normal
IPv6 operations.
◆
Setting the neighbor solicitation interval to 0 means that the configured time is
unspecified by this router.
Example
The following sets the interval between sending neighbor solicitation messages to
30000 milliseconds:
Console(config)#interface vlan 1
Console(config)#ipv6 nd ns-interval 30000
Console(config)#end
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
fe80::269:3ef9:fe19:6779%1/64