Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 381 / 1116

Chapter 10
| Interface Commands
Transceiver Threshold Configuration
– 381 –
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
The threshold value is the power ratio in decibels (dB) of the measured power
referenced to one milliwatt (mW).
◆
Refer to the Command Usage section under the transceiver-threshold current
command for more information on configuring transceiver thresholds.
◆
Trap messages enabled by the transceiver-monitor command are sent to any
management station configured by the snmp-server host command.
Example
The following example sets alarm thresholds for the signal power received at port
1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold rx-power low-alarm -21
Console(config-if)#transceiver-threshold rx-power high-alarm -3
Console#
transceiver-threshold
temperature
This command sets thresholds for the transceiver temperature which can be used
to trigger an alarm or warning message.
Syntax
transceiver-threshold temperature { high-alarm | high-warning | low-alarm
| low-warning } threshold-value
high-alarm – Sets the high temperature threshold for an alarm message.
high-warning – Sets the high temperature threshold for a warning
message.
low-alarm – Sets the low temperature threshold for an alarm message.
low-warning – Sets the low temperature threshold for a warning message.
threshold-value – The threshold of the transceiver temperature.
(Range: -20000 - 20000 in units of 0.01 Celsius)
Default Setting
High Alarm: 75.00 °C
HIgh Warning: 70.00 °C
Low Warning: 0.00 °C
Low Alarm: -123.00 °C
Command Mode
Interface Configuration (Ethernet)