Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 187 / 1116

Chapter 5
| SNMP Commands
SNMP Target Host Commands
– 187 –
Related Commands
snmp-server host (187)
snmp-server host
This command specifies the recipient of a Simple Network Management Protocol
notification operation. Use the
no form to remove the specified host.
Syntax
snmp-server host host-addr [ inform [ retry retries | timeout seconds ]]
community-string [ version { 1 | 2c | 3 { auth | noauth | priv } [ udp-port port ]}
no snmp-server host host-addr
host-addr - IPv4 or IPv6 address of the host (targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
inform - Notifications are sent as inform messages. Note that this option is
only available for version 2c and 3 hosts. (Default: traps are used)
retries - The maximum number of times to resend an inform message if
the recipient does not acknowledge receipt. (Range: 0-255; Default: 3)
seconds - The number of seconds to wait for an acknowledgment
before resending an inform message. (Range: 0-2147483647
centiseconds; Default: 1500 centiseconds)
community-string - Password-like community string sent with the
notification operation to SNMP V1 and V2c hosts. Although you can set this
string using the
snmp-server host command by itself, we recommend
defining it with the snmp-server community command prior to using the
snmp-server host command. (Maximum length: 32 characters)
version - Specifies whether to send notifications as SNMP Version 1, 2c or 3
traps. (Range: 1, 2c, 3; Default: 1)
auth | noauth | priv - This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See “Simple
Network Management Protocol” in the
Web Management Guide for
further information about these authentication and encryption
options.
port - Host UDP port to use. (Range: 1-65535; Default: 162)
Default Setting
Host Address: None
Notification Type: Traps
SNMP Version: 1
UDP Port: 162
Command Mode
Global Configuration