Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 481 / 1116

Chapter 18
| VLAN Commands
Configuring VLAN Interfaces
– 481 –
The following figure shows VLANs 1 and 2 configured on switches A and B, with
VLAN trunking being used to pass traffic for these VLAN groups across switches
C, D and E.
Figure 3: Configuring VLAN Trunking
Without VLAN trunking, you would have to configure VLANs 1 and 2 on all
intermediate switches – C, D and E; otherwise these switches would drop any
frames with unknown VLAN group tags. However, by enabling VLAN trunking
on the intermediate switch ports along the path connecting VLANs 1 and 2,
you only need to create these VLAN groups in switches A and B. Switches C, D
and E automatically allow frames with VLAN group tags 1 and 2 (groups that
are unknown to those switches) to pass through their VLAN trunking ports.
◆
To prevent loops from forming in the spanning tree, all unknown VLANs will be
bound to a single instance (either STP/RSTP or an MSTP instance, depending on
the selected STA mode).
◆
VLAN trunking is mutually exclusive with the “access” switchport mode (see the
switchport mode command). If VLAN trunking is enabled on an interface, then
that interface cannot be set to access mode, and vice versa.
◆
If both VLAN trunking and ingress filtering are disabled on an interface, packets
with unknown VLAN tags will still be allowed to enter this interface and will be
flooded to all other ports where VLAN trunking is enabled. (In other words,
VLAN trunking will still be effectively enabled for the unknown VLAN).
Example
The following example enables VLAN trunking on ports 9 and 10 to establish a path
across the switch for unknown VLAN groups:
Console(config)#interface ethernet 1/9
Console(config-if)#vlan-trunking
Console(config-if)#interface ethernet 1/10
Console(config-if)#vlan-trunking
Console(config-if)#