Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 1048 / 1116

Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
– 1048 –
PIM6 Shared Mode Commands
router pim6
This command enables IPv6 Protocol-Independent Multicast routing globally on
the router. Use the
no form to disable PIM multicast routing.
Syntax
[ no ] router pim6
Default Setting
Disabled
Command Mode
Global Configuration
PIM-DM Commands
ipv6 pim graft-retry-interval Configures the time to wait for a Graft acknowledgement
before resending a Graft message IC
ipv6 pim max-graft-retries Configures the maximum number of times to resend a
Graft message if it has not been acknowledged IC
ipv6 pim state-refresh
origination-interval Sets the interval between PIM-DM state refresh control
messages IC
PIM-SM Commands
ipv6 pim bsr-candidate Configures the switch as a Bootstrap Router (BSR)
candidate GC
ipv6 pim register-rate-limit Configures the rate at which register messages are sent by
the Designated Router (DR)
GC
ipv6 pim register-source Configure the IP source address of a register message to an
address other than the outgoing interface address of the
designated router (DR) leading toward the rendezvous
point (RP) GC
ipv6 pim rp-address Sets a static address for the rendezvous point GC
ipv6 pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ipv6 pim spt-threshold Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode GC
ipv6 pim dr-priority Sets the priority value for a DR candidate IC
ipv6 pim
join-prune-interval Sets the join/prune timer IC
clear ipv6 pim bsr rp-set Clears RP entries learned through the BSR PE
show ipv6 pim bsr-router Displays information about the BSR PE
show ipv6 pim rp mapping Displays active RPs and associated multicast routing
entries PE
show ipv6 pim rp-hash Displays the RP used for the specified multicast group PE
Table 205: PIM-DM and PIM-SM Multicast Routing Commands
(Continued)
Command Function Mode