Edelbrock Pro-Tuner, Руководство пользователя

Страница: 52 / 235

52
ground wires, fuel pump harness and ignition harness ground black leads to the same
point using clean & paint-free bell housing bolt connection. Alternatively, you may
connect the system grounds to the same point on the engine as the battery negative
lead. Insure that the engine/transmission is grounded to the chassis and body as well.
See Figure 20 for system Grounding at bell housing. Note Negative battery cable and
paint removed from bell housing under terminal contact area.
Figure 20
If space is confined, an alternative method is to run system power to a firewall mounted
insulated hot-stud and a single 6/8 gauge wire to the starter solenoid.
•
Connect ignition key-switch lead to the operator ignition switch. The switch should
be capable of maintaining uninter12V power to the system in the “On”
position, “Crank” position, as well as the transition between the two. Many older
vehicles (pre 1974) have ignition switches that bypass power from a ballast
resistor during crank and these systems typically have a momentary “dropout”
between the Run and Crank positions.
These types of ignition switches ARE NOT COMPATIBLE with your Edelbrock
Pro-Tuner system.
If you have such a switch; it must be replaced with a newer non-interruptible
version for proper operation.
•
Connect remaining wires, including fuel pump and ignition harnesses. Unused
connectors should be coiled and secured away from dirt, debris, and heat.