Edelbrock Pro-Tuner, Руководство пользователя

Страница: 16 / 235

16
•
Intake Manifold - Fuel Rail Assembly
•
Edelbrock High Flow 60 pph Fuel Injectors
•
Four barrel Throttle Body w/integrated TPS sensor & Idle Air Control valve
•
Heated Oxygen sensor w/mounting bung
•
1 bar Manifold Absolute Pressure (MAP) sensor
•
Intake Air Temperature (IAT) sensor
•
Engine Coolant Temperature (ECT) sensor
•
Firewall bulkhead grommet/cover plate assembly
Additional Hardware and Parts needed:
•
Intake Gaskets / other engine gaskets as required
•
Edelbrock/GM/or equivalent
•
5/16” steel tubing (approximate equal length to fuel pickup in tank)
•
Edelbrock Gasgacinch #9300
•
Loctite 598 OEM High Temperature Silicone gasket (O2 sensor compatible)
•
Radiator Coolant - Teflon paste thread sealant
•
Manifold bolt kit
•
Factory service manual & wiring diagrams
Preliminary Checklist:
•
CAREFULLY STUDY AND UNDERSTAND ALL INSTRUCTIONS .
•
Examine the system components and packaging for shipping damage. (If
damaged, contact your dealer immediately)
•
Check all threaded manifold holes.
•
Check all internal manifold passages with a light and wire, making sure they are
clean and unobstructed.
•
Check automatic transmission shift points before removal of the stock system, and
adjust linkage after Edelbrock manifold installation for same shift points if needed.
Determining Hood Clearance
1. CHECK HOOD CLEARANCE BEFORE REMOVING STOCK MANIFOLD.
2.
Use modeling clay or putty to make five small cones 2-3” high.
3. Position cones on air cleaner at front, rear, each side, and on center stud.
4. Close hood fully and reopen.
5. The heights of the cones indicate the amount of clearance between the hood and
the air cleaner. Record the measurements.