Edelbrock Pro-Tuner, Руководство пользователя

Страница: 19 / 235

Installation and Setup 19
The 200R4 and 700R4 transmissions require precise adjustments. We
recommend that you consult a reputable transmission shop for final adjustment
once the Victor system has been installed.
INCORRECT SHIFT POINTS CAN RESULT IN TRANSMISSION DAMAGE!
ENGINE CLEANING:
Always perform the installation with a clean engine and engine compartment. Use utmost
care in the cleanliness of
ALL parts during the process.
EXHAUST MANIFOLD HEAT RISER:
If your vehicle is equipped with an exhaust manifold heat riser (typically located on the
passenger side of the vehicle under the exhaust manifold), remove the valve for proper
operation.
HEADERS:
For best performance, headers are recommended. Consult Edelbrock or your exhaust
supplier for recommendations on header, pipe, and muffler specifications for your
combination.
INSTALLING THE EFI INTAKE MANIFOLD:
The procedure for installing your new EFI manifold is nearly identical to installing a
carbureted manifold. Always install new gaskets per manufacturer recommendation and
follow the Edelbrock torque specifications for your particular manifold.
PRE-INSTALLATION
Before installing the induction system, take the following steps to ensure successful
installation and performance:
1. Check all components thoroughly for damage when unpacking.
2. Make sure all throttle linkages open entirely and close freely.
3. Make sure all fuel inlet and vacuum ports are free from packing material.
4. Check the installation kit for proper parts.
REMOVING THE STOCK CARBURETOR AND MANIFOLD
1. Disconnect battery.
2. For ease of installation, keep all parts in order.
CAUTION: Do not remove manifold if engine is hot.
3. Drain radiator coolant (radiator drain plug is typically located on lower right facing
engine).
4. Remove gas cap to relieve pressure. Disconnect fuel line and plug. Replace gas
cap.
5. Disconnect all linkage from carburetor such as throttle, throttle springs,
transmission, cruise control and automatic choke.
6. Tag and remove coil wires and sensor wires.
7. Remove previously marked vacuum lines.
8. Remove radiator hose, thermostat housing and thermostat, if mounted on
manifold.
9. Remove all brackets from the manifold.
10
.
Loosen or remove valve cover bolts for manifold removal and replacement. It may
be necessary to replace valve cover gaskets if broken, to prevent oil leakage.