Installing the Ergonomic Workstation
3.
From the bottom of the rear surface, drill two holes to approximately .250” diameter
through the bottom backer material. This will prevent chipping of backer material.
4. From the top rear surface, use the pilot holes to drill two 2.50” holes down through the
laminate and completely through the deck using a 2-1/2” diameter hole saw.
Attach Rear Surface Trim Panels
Follow these instructions and refer to the illustration below to attach the rear surface trim
panels.
1.
From the bottom rear surface, insert the front curved panel (22163X or 21616X) into the
slot in the bottom front of the deck.
Step
(2x)
23
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011
Side Panels (2)
Front Panel
Step
(2x)
Step
Step
(2x)
Rear Surface
2. Insert two Phillips wood screws (62071) through the panel into the rear surface and
tighten.
3. From underneath the rear surface, insert a side curved panel (21615X or 22162X) into the
slot in the bottom side of the surface as illustrated above.
4. Insert two Phillips wood screws (62071) through the panel into the surface and tighten.
5. Repeat steps 3 and 4 to attach the other side curved panel.
6. Install two (2) thread form (66714) #10-32 screws through front panel into both side
panels.
