Installing the Ergonomic Workstation
Level Assembled Components
Follow these instructions and refer to the illustration below to level the components that have been
assembled at this point, including the leg assemblies as well as the lift column.
WARNING:
Failure to follow these instructions may result in improper installation and potential
product damage.
1. Make sure the lift column base levelers are extended at least 3/4” prior to leveling.
Lift Column (DL2)
Leg Assemblies
(DL6)
Step
Step
Step
Step
Step
2. Using a spirit level (bubble level) instrument, level the unit front to back as well as side to side as
shown above.
3. Ensure that both leg assemblies (DL6) are plumb 90º to the base as illustrated above.
4. Ensure the lift column (DL2) is plumb 90º to the base as illustrated above.
IMPORTANT:
Do not proceed to the next step until the product is completely level.
wwww.eaton.com/powerquality 11-41 06-2011
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 16
