Installing the Ergonomic Workstation
Attach Center Column Cable Chains
Follow these instructions to attach the cable chain bracket and chains.
1. Place the cable chain support bracket to the bottom rear of the rear surface support beam.
Rear Surface
Support Beam
Step
Step
(6x)
Step
(6x)
Step
Cable Chains
Step
Step
(6x)
2. From underneath the beam, insert six Phillips thread form screws (66714) through the
cable chain bracket into the bottom of the support beam and tighten to attach the support
bracket to the rear surface support beam.
3. Attach the top of both cable chains to the rear of the support bracket using three Phillips
head machine screws (18618) on each side and tighten.
4. Attach the bottom of both cable chains to the rear of the lower support frame using three
Phillips screws (18618) on each side and tighten.
21
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011
