Chapter 1 Before you Begin
Introduction
The Profile Genesys Dual-Lift Ergonomic Workstation is an ergonomic solution designed for
command and control environments such as Emergency Operations Centers, Network Operations
Centers, Process Control Environments, Medical Imaging Reading Rooms, and more. This
workstation solution accommodates all computing, networking, and electrical cabling required in a
modern command and control environment. The dual lift surfaces allow users to adjust their working
postures to comply with the most current ergonomic recommendations. The rear surface and user
surface are electronically and independently adjustable.
This document describes how to install the Profile Genesys Dual-Lift Ergonomic Workstation in a
work environment.
CAUTION:
To prevent personal injury and product damage, it is strongly recommended that the
unpacking, moving, and assembly processes be performed by two or more people.
Important Safety Information
Please follow these safety guidelines as you unpack, move, and assemble the components of the
workstation. Adherence to these guidelines will prevent personal injury and potential product
damage.
When lifting units, there should be at least one person for every 40 lbs. of weight to be lifted.
Do not, under any circumstance, stand on the Profile workstation.
Do not stand on Profile workstations to load monitors.
Site Preparation
It is the customer’s responsibility to clear and prepare the site before installing the workstation.
Generally, site preparation includes the following actions, which are provided as a guideline only and
not intended as a complete list of site preparation tasks.
Access to site drawings to determine where workstation will be installed
Clear the area to accommodate the workstation
Tape off the floor where workstation is going to be installed
Ensure that power requirements are met
In this Chapter
Refer to the following table for information on a specific topic.
Topic
See Page #
Important Safety Information
1
Site Preparation
1
Tools you Will Need
2
Fasteners you Will Be Using
2
Washers and Grommets you Will Be Using
3
1
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011