Installing the Ergonomic Workstation
Install the Rear Cover
Once all the cables have been routed, you will need to install the rear cover to the rear surface.
To install the rear cover to the rear surface, do the following:
1. Attach the rear cover (21616X) to the rear surface by inserting three (3) #10A x 1” Phillips
pan head screws (62071) through the rear cover and into the rear surface and tighten.
Rear
Surface
Rear Cover
Step
(3x)
2. The rear cover installation is now complete.
You have successfully installed the Profile Genesys Ergonomic Workstation. Proceed to the
following section for instructions on initializing the system.
31
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation www.eaton.com/powerquality 11-41 06-2011
