Installing the Ergonomic Workstation
Install Rear Surface and Trim Assembly
Follow these instructions to install the rear surface and trim assembly.
Attach Rear Surface Support Beam
Follow these instructions and refer to the illustration below to attach the rear surface support frame.
NOTE:
This procedure requires a team of two people to align the beam and stabilize it until the
fasteners are secure.
1. Align the rear surface support beam over the top of the lift column.
2. From above the beam, insert four TORX M8x35 flathead screws through the beam into the lift
column and tighten.
NOTE:
Cross-tighten the screws in an X pattern (as shown in the detail view
below), being careful not to over tighten.
wwww.eaton.com/powerquality 11-41 06-2011
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 20
Step
See Detail
(4x)
Detail Shown
