Installing the Ergonomic Workstation
Attach Lift Control Box and Operator Control Pad
Follow these instructions and refer to the figure below to attach the power control box and
power control pad to the bottom of the user surface.
1.
From underneath the user surface, attach the lift control box (90066) to the center rear
section of the surface. Insert four Phillips wood screws (62071) and tighten.
User Surface
Power Control
Box
Step
(4x)
2.
From the underneath the user surface, attach the operator control pad bracket (96239) to
the left front of the surface as shown in the illustration below.
NOTE:
The control pad can
be mounted in different locations under the user deck, depending on the configuration.
For instructions on calibrating and operating the control pad, refer to Chapter 5.
3. Insert two Phillips wood screws (62071) and tighten.
Power Control
Pad
Step
(2x)
4. Slide the control pad firmly into the support bracket until it clicks into place.
www.eaton.com/powerquality 11-41 06-2011
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation 28
