Chapter 2 Pre-Installation Preparation and Planning
This chapter describes the preparation and planning involved prior to installing the Profile Genesys
Dual-Lift Ergonomic Workstation.
Prerequisites
The core-to-core assembly must be complete before the ergonomic workstation installation can
occur. For instructions on how to install the core-to-core assembly, refer to the
Profile Flat Panel
Console System Installation Manual
at our website
, http://www.wrightline.com
.
IMPORTANT:
Build the workstation independent from the core. Once the core assembly is
complete, then the fully-assembled workstation can be aligned with the core per the instructions in
this manual.
Installation Overview / Checklist
The following checklist is intended to be a quick reference to ensure all hardware components of the
Profile Genesys Dual-Lift Ergonomic Workstation are installed in the proper order. For further
information on any of these steps, refer to the detailed instructions in the corresponding section of
this manual.
Topic
Refer to..
Install the Rear Lift Column Assembly
10
Install the Front Lift Column Assembly
12
Install the Rear Surface and Trim Panels
20
Install the User Surface and Components
25
Installation Options for the G111 Series
33
Tools you Will Need
Refer to the tools listed in Chapter 1 to properly install the workstation.
Fasteners you Will Be Using
Refer to Chapter 1 for a list of fasteners you will be using to install the workstation.
In this Chapter
Refer to the following table for information on a specific topic.
Topic
See Page #
Prerequisites
5
Installation Overview / Checklist
5
Tools you Will Need
5
Fasteners you Will Be Using
5
Unpack the Box Contents
6
Workstation Components
7
Lifts Covered in this Manual
8
5
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation wwww.eaton.com/powerquality 11-41 06-2011
