46
Compass
Installation Manual
COMPASS INSTALLATION MANUAL
www.eaton.com/compass
Install Cabinet Doors
Cabinet doors attach to the front of overhead
compartment shells.
Requirements:
•
Installed legs, stretchers, organizer uprights, panels
and overhead storage compartments
Components:
•
Cabinet door assemblies
Hardware - COMPKIT8 & COMPKIT9
•
#lock hardware
•
#8-32 x
7
⁄
8
machine screws
•
#8 x
3
⁄
8
pan head wood screws
Tools required (not included)
•
Powered driver
•
#2 Phillips screwdriver
•
7
⁄
8
Open end box wrench
Before installing cabinet doors they must be
assembled as described in the Assemble Cabinet
Doors section.
Complete this procedure to install cabinet doors.
1. With the hinges in the open position, align the
hinges with hinge plates in the hinge bracket.
Insert both hinges into the hinge plates. Two
hooks on the hinge catch the front edge of the
hinge plate and a rear latch snaps into the cutout
in the hinge plate. The rear latch must snap firmly
into place or the hinges will fail.
To remove a hinge, press the hidden button at the
rear of the hinge to release the rear hooks. Slide
the door forward to remove.
The screws in the front of the hinge are used for
alignment.
2. Test closing and opening the door to make sure
the hinges are properly seated.
3. Using a
3
⁄
16
drill bit, drill out the holes for the
door handle. Suggested top, middle, and bottom
handle locations are partially pre-drilled.
The customer must specify the location of the
door handles. Handle location can be customized
in the field to meet customer requirements.