44
Compass
Installation Manual
COMPASS INSTALLATION MANUAL
www.eaton.com/compass
Assemble and Install Cabinet Door
Hinge Brackets
Before installing cabinet doors the hinge plates and
hinge brackets must be assembled and installed as
described in this section.
Assemble Cabinet Door Hinge Brackets
Hinge plates connect to cabinet door hinge brackets.
Components:
•
Cabinet door hinge brackets
Hardware - COMPKIT8 & COMPKIT9
•
Hinge plates
•
#10-24 x
3
⁄
8
self tapping screws
Tools required (not included)
•
Powered driver
•
#2 Phillips bit
Complete this procedure to assemble hinge plates
and hinge brackets.
1. Align two hinge plates with the dimpled holes
in one hinge bracket. The hinge plates must be
oriented with the cutout toward the center of the
stiffener and the open end near the front edge of
the stiffener.
For compartments 42 to 54 inches wide, an
intermediate shell partition is provided. Hinge
plates must be attached to only one side as
determined by the customer’s door configuration.
For compartments 60 to 72 inches wide, a center
shell partition is provided. Hinge plates must be
attached to both sides.
2. Insert two #8 self tapping screws through each
hinge plate into the hinge bracket. Align the
screws with the centerlines of the hinge plate
slots. Tighten the screws.
NOTICE
Note:
Make sure the hinge plates are oriented to
be on the front edge of the hinge bracket or
shell partition when installed in the overhead
compartment.
Repeat steps
1
and
2
to assemble each required
stiffener