19
Compass
Installation Manual
COMPASS INSTALLATION MANUAL
www.eaton.com/compass
Assemble Legs
If legs are shipped unassembled or partially
assembled, complete the procedures in this section
to assemble legs.
Assemble Full Legs
If full legs are shipped unassembled or partially
assembled, complete this procedure to assemble the
full legs.
Components:
•
Full leg unassembled
Hardware - COMPKIT1
•
1
⁄
4
-20 x
1
⁄
2
Hex Head Self Tapping Screws
•
1
⁄
4
-20 x
3
⁄
4
Hex Head Machine Screws
Tools required (not included)
•
Powered driver
•
3
⁄
8
hex socket
Any additional hardware required for assembly is
attached to leg components.
Complete this procedure to assemble a full leg.
1. Position the mounting bracket with the flanges
even with the inner side of the leg as shown.
Insert two
1
⁄
4
-20 x
1
⁄
2
self tapping hex screws
through the bracket into the holes in the front
edge of the leg and tighten.
NOTICE
Note:
Do not over-tighten.
2. Align the three slots in the panel with the three
flanges in the mounting bracket. Slide the flanges
into the slots in the panel.
3. Insert three
1
⁄
4
-20 x
3
⁄
4
machine hex screws
through the holes in the panel into the threaded
holes in the flanges and tighten. Full leg assembly
is complete.
4. Repeat these steps until all full legs needed in
this stage of the installation are assembled, then
continue to the next section.