39
Compass
Installation Manual
COMPASS INSTALLATION MANUAL
www.eaton.com/compass
7. If the compartment requires a partition, complete
steps
a
and
b
.
For overhead compartment shells 60 inches or
wider, a center shell partition is included.
For overhead compartment shells 42 to 54 inches
wide using cabinet doors, an intermediate shell
partition is included with the doors.
NOTICE
Note:
For compartments with three cabinet
doors, the customer must specify the door
configuration which determines the location of
the intermediate shell partition.
If the compartment will be configured with
cabinet doors, and is 42 inches wide or wider,
attach the hinge plates before installing the
partition. See the Assemble Cabinet Doors
section.
a. Align the shell partition with the slots in the
shelf. Insert the tabs on the bottom of the
shell partition through the slots in the shelf.
b. From underneath the shelf, insert two screws
through the holes in the shelf into the shell
partition and tighten.
8. At the top flange of the side panels, partially
insert six screws, three per side, into the smaller
holes in the side flanges.
9. Position the top panel above the rear panel,
side panels, and shell partitions—if used in this
configuration. Lower onto the partially inserted
screws. Tighten the screws.
10. If there is a partition, insert a self tapping screw
through the flange in the top panel into the hole in
the front of the partition and tighten.
11. Tighten all overhead compartment screws
installed to this point.
Repeat these steps for all overhead compartments in
this stage of the installation.
Worksurface tie plates are required between all
flanking worksurfaces.
Install tie plates during the
Install Worksurfaces section.