Eastey EA Professional Series, Руководство пользователя

Страница: 20 / 70

20 Installation
Connecting Power
Before bringing power to the unit, electrical cables from the L-Sealer/Exit Conveyor
module must be connected to the PFU/Infeed Conveyor/Inverter module and to the
Scrap Film Take-up Spool module. In each case, the cable originates from the L-
Sealer/Exit Conveyor module and individual wires must be connected to a terminal
block either inside an electrical box attached to the Infeed Conveyor base, or inside the
enclosure which makes up the vertical body of the Scrap Film Take-up Spool module.
For the cable which connects the L-Sealer module to the Infeed Conveyor module,
make sure the locknut for the 90° conduit elbow is on the cable before making
connections.
Infeed Conveyor Electrical Junction Inside Scrap Film Take-up Spool Body
Note: When installing the cable from the L-Sealer/Exit Conveyor
module to the PFU/Infeed Conveyor Inverter module, place
the conduit elbow (provided) onto the cable end, and then
feed it into the side of the electrical box.
A power cord (with optional electrical plug) should be installed by a licensed electrician.
CAUTION! Before operating, ensure the following.
1. All shipping ties are removed.
2. All personnel are clear of the equipment.
3. Electrician has stated that all electrical work is complete.
4. Close all doors or guards securely.
5. Connect air line to regulator and verify 60 PSI, 3.5 CFM.
6. Adjust all controls according to the settings sheet.
Refer to instructions in the Operation section for instructions to power up or shut down
the machine.
L 1
Blue
A+
F-
Red
ACCEL
DECEL
EN
CO
NN1
P2
PW
R O
N
I1
T
B
F+
A-
CL
L2
P3
MAX
P1
MIN
I2
IR CL
J1
®
Refer to
Electrical
Schematics
for wiring.
Green wire to ground stud.
Gray wire to
terminal block.
Black wire to
terminal block.
Refer to
Electrical
Schematics
for wiring.
Refer to
Electrical
Schematics
for wiring.
Elbow Lock
Nut
Cable