Eastey EA Professional Series, Руководство пользователя

Страница: 35 / 70

Operation 35
2. Place the free-standing scrap take-up spool to the side of the L-sealer, aligned
with the exiting scrap, but so that the L-sealer frame will not interfere with rotation
of the take-up spool. Route the scrap under the attached weighted tensioning rod
and start it onto the spool.
•
The scrap take-up spool has an On/Off switch and speed control not
controlled by the main L-sealer controls. It must be powered on and speed
control set to operate with the L-sealer.
• The scrap take-up spool has a clutch to set the tension. Instructions for
adjusting clutch tension are provided in the Adjustments section.
NOTE: If there is too much tension on the film while the bag is being
sealed, the seals will be more likely to be weak or blow out in the
seal area while moving through the shrink tunnel.
Adjusting Package Height
Use these steps to adjust the height of the seal / cutter for higher or lower packages.
1. Turn off seal bar heat and allow to cool down before adjusting seal head.
2. Touch the “Head Setup / Run” button on the Operator’s panel and the seal head
will come together.
Position
Scrap Film
Take-Up
Spool In Line
With Exiting
Scrap Plastic
Weighted
Tensioner
Rod
On/Off
Switch and
Spool
Speed
Control Are
On Top Of
Spool
Electrical
Box