Eastey EA Professional Series, Руководство пользователя

Страница: 16 / 70

16 Installation
Installation
Place the sealer in the desired location with the required electrical power source
available. (See power requirements for the specific model in the Specifications table.)
Make sure the electrical wiring is adequate to provide the required voltage. If the voltage
provided is too low, the equipment will not operate correctly.
Selecting the proper location is one of the most important considerations for initial
setup. When selecting the location, take into consideration the following factors.
1. Adequate clean dry air and power supply nearby?
2. Where is the sealer in relation to the power source?
3. Where is the sealer in relation to the tunnel and any conveyor(s) necessary to
move the wrapped product? (Alignment with packaging line.)
4. Convenience for the operator.
CAUTION! Avoid locating the L-sealer in a cold or drafty area, as heat
may be unintentionally drawn from the sealer and reduce its
efficiency.
If there is any doubt, get qualified assistance with your initial installation.
Location Requirements
When installing the L-sealer please be aware of the following considerations:
1. The surface on which it is located is flat and level.
2. Conveyor or packing table height.
3. Alignment with packaging line.
When the L-sealer is positioned in the operating location you will need access to:
1. Control panel switches: On/Off switch, dwell timer, conveyor timer.
2. Height and width adjustments.
3. Film unwinder.
For units equipped with a takeaway conveyor at the exit of the L-sealer, provision
should be made for exiting packages. For example, a table or bin where packages that
have been sealed will be placed until they can be picked up, or a conveyor that will
move them to the tunnel.