DynaGen Tough Series, Руководство пользователя

Страница: 25 / 66

Using the Controller 24
© 2019 DynaGen Technologies Inc
TOUGH Series Manual
Sensor 2
Run Event The controller has auto started due to a auxiliary sensor 2 "start on low" or "start on high" request.
Sensor 1
Stop Event The controller has shutdown due to a auxiliary sensor 1 "start on low" or "start on high" stop request.
Sensor 2
Stop Event The controller has shutdown due to a auxiliary sensor 2 "start on low" or "start on high" stop request.
Switch
Start Event A controller start was triggered by the momentary start switched input.
Switch
Stop Event A controller start was triggered by the momentary start switched input.
Regen
Inhibited Event Electronic engines with a Diesel Particulate Filter (DPF) only. The user requested that the automatic
regeneration of the DPF be disabled.
Force
Regen Event Electronic engines with a Diesel Particulate Filter (DPF) only. The user requested a manual
regeneration of the DPF.
Auto
Regen Event Electronic engines with a Diesel Particulate Filter (DPF) only. The engine ECM has performed an
automatic regeneration of the DPF.
Sensor 3
Run Event The controller has auto started due to a auxiliary sensor 3 "start on low" or "start on high" request.
Sensor 4
Run Event The controller has auto started due to a auxiliary sensor 4 "start on low" or "start on high" request.
Sensor 3
Stop Event The controller has shutdown due to a auxiliary sensor 3 "start on low" or "start on high" stop request.
Sensor 4
Stop Event The controller has shutdown due to a auxiliary sensor 4 "start on low" or "start on high" stop request.
Log Time
start Event A user has started the controller using the RUN button and the long time run feature is enabled under
Timers > Long Time Run. The controller will run for the duration specified under "Long Time Run"
and then automatically shut down.
Scheduler
Start Event The controller has auto started due to a daily schedule set up in Timers > Week Scheduler.
Start
Canceled Event A daily scheduler was canceled either because the controller was not in AUTO mode or start request
was ignored. A start request being ignored is an internal error and should not occur.
J1939 Start Event Controller started from J1939 using the second J1939 start/stop method. Refer to the J1939 user
guide for more information. This is often used by telemetry devices to start/stop the controller.
Crank
Failed Warning The controller has turned it's crank output but has failed to detect the engine is running. After crank
rest (if programmed under Timers > Engine Logic) it will try again.
Low Batt
InCrank Warning During cranking the battery was lower than normal. The level is set under Sensors > Battery.
Charger
Fault Warning Indicates a battery charger issue. The controller has a battery charger fault switched input. This is
used to indicate to the controller the charger has a fault.
High Fuel
Level Warning The fuel level raised above the high fuel level warning threshold set under Sensors > Fuel Level.
Potential over fueling issue.
Under
Voltage Warning The generator AC voltage has fallen below the under voltage warning setpoint set under AC Monitor
> Genset Voltage. Possible issue with the voltage regulator or governing on the engine.
Under
Speed Warning The generator speed has fallen below the under speed warning setpoint set under Sensors > Engine
Speed.
Over
Speed Warning The generator speed has risen above the over speed warning setpoint set under Sensors > Engine
Speed.
High
Engine
Temp Warning The engine temperature has risen above the high engine temperature warning under Sensors >
Engine Temp.
Low Oil
Pressure Warning The oil pressure has fallen below the low oil pressure warning setpoint under Sensor > Oil Pressure.
Low Fuel
Level Warning The fuel level has fallen below the low fuel level warning setpoint under Sensors > Fuel Level.