32 |
3A Adjusting Knife Pressure and Stretch Factor
Knife Pressure and Stretch Factor settings can be found in Primera Print Hub on the Printer Settings Tab for
the LX610e Click the Advanced Settings button to view these settings.
Pressure affects how deep into the media the knife will
cut. Ideally you want to cut deep enough to cut through
the label layer on the top but not so deep that you cut
through the backing paper. When you cut through the
backing paper your label will not peel cleaning off the
backing paper. You will also score the wear strip under
the cutting knife. It will then need to be replaced more
often.
By default, the cutter is calibrated towork with High
Gloss Paper Media. However, other media types
will need more or less cut pressureto cut properly.
Each roll of media
will have a recommended value
to add or subtract from the default baseline value
usedfor High Gloss media. Thedefault value is zero. For
Magneticmedia,stretch factor will need to be adjusted
to compensate for the thicker material and different feed speed.
Содержание LX610e
