Dräger RW82, Инструкция по эксплуатации, Страница: 105 / 126

PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
5 - 17
Cart and Bassinet
End and Side Panels
CAUTION:
Do not attempt to move the cart and bassinet by using the acrylic end and side panels as a
handle. Use the rear handle when moving the equipment. Equipment damage could occur.
WARNING:
When the panels are down, do not leave the infant unattended. Patient injury could occur.
WARNING:
All panels must be erect and secure during transport. Failure to do so could result in patient
injury.
Side Panels
1. To lower a side panel, raise it, pivot it outward, and let it hang down.
2. To raise a side panel, rotate the bottom of the panel upward until it is at the top, and let the panel
lower into place.
Front Panel
1. To lower a front panel, raise it, pivot it outward, and slide it under the mattress.
2. To raise a front panel, pull it out from under the mattress, rotate it until it is vertical, and let it lower
into place.
Back Panel
You can either remove the back panel, or pivot it slightly.
1. To remove the back panel, raise it straight up and out
of the corner bracket.
2. To replace it securely, hold it vertically, slide the lower
pins into the opening half-way down the corner
bracket, and let it drop into place.
3. To pivot it slightly, remove it, and reinsert its lower
pins into the top of the corner bracket. The panel pivots
on its own.
4. To replace the back panel after allowing it to pivot,
follow these steps:
a. Lift it vertically from the top of the corner bracket.
b. Holding it vertically, slide its lower pins into the opening half-way down the corner bracket, and
let it drop into place.
Bassinet Tilt Control
To operate the bassinet tilt control, perform the following:
1. Support the rear lower edge of the bassinet with your palm, and pull up on the lever at the bottom rear
of the bassinet.