Dini Group DN9002K10PCI, Руководство пользователя

Страница: 20 / 169

Q U I C K S T A R T G U I D E
Figure 3 DN9002K10PCI configuration controls
The FPGAs on the board are names “FPGA A” through “FPGA F” FPGA A is in the lower
left hand corner as shown in the above photo. FPGA B and C are to its right. The top row of
FPGAs from left to right be named, “FPGA D”, “FPGA E”, and “FPGA F”
To begin working with the DN9002K10PCI, follow the steps below.
3.1 Install Memory
The DN9002K10PCI comes packaged without memory installed. If you want the Dini Group
reference design to test your memory interfaces, you must install memory modules in the
SODIMM slot on the board. The reference design supports DDR2 SODIMM modules in
densities 256MB, 512MB, and 1GB with a CAS latency of 3. (Almost any modern off-the-shelf
laptop memory)
The socket DIMMB is connected to FPGA B. The socket can accept any capacity DDR2
SODIMM module. Note that DDR1 modules will not work in these slots since they are a
completely different pin-out and voltage level.
3.2 Prepare configuration files
The DN9002K10PCI reads FPGA configuration data from a CompactFlash card. To program
the FPGAs on the DN9002K10PCI, FPGA design files (with a .bit file extension) put on the
root directory of the CompactFlash card file using the provided USB card reader.
The DN9002K10PCI ships with a 256MB CompactFlash card preloaded with the Dini Group
reference design. These “bit” files can also be found on the User CD. You can also compile the
reference design source (provided on the CD) and place the generated .bit files on the Compact
Flash card.
DN9002K10PCI User Guide www.dinigroup.com 10