Managing the DECserver 90L+
RESET Command
The RESET command allows you to reset individual ports or server parameters
to their power-up state and run the unit’s self-test. Resetting the server sets all
port and server parameters to their power-up state, disconnects all sessions, and
runs a self-test. When the DECserver 90L+ is in authorized mode, the port you
are using must be in manager mode to reset another port or the server.
Ports that have not had their speed set using the SET command will be returned
to the non-autobaud state (no speed set). After being reset, press the
Return
key
twice to autobaud a port and set the speed.
RESET Command by Menu
The following example shows the RESET command used to reset port 1. The
example shows the command entered interactively.
1.
Enter RESET at the DECserver 90L+ prompt and press
Return
. The asterisk
(*) indicates the port to which you are connected, in this case Port 1.
2.
Enter 1 and press
Return
.
-> RESET
Return
|1 PORT_1*
|2 PORT_2
|3 PORT_3
|4 PORT_4
|5 PORT_5
|6 PORT_6
|7 PORT_7
|8 PORT_8
|S Server
|
|1
Return
-> %DS90L-110, Port Has Been Reset
->
RESET Command by Command Line
The command line to reset is:
-> RESET 1
Return
-> %DS90L-110, Port Has Been Reset
->
4–50 Managing the DECserver 90L+
