Installing the DECserver 90L+
Make Connections.
1.
Plug the power supply into the DECserver 90L+.
2.
Attach the Ethernet T-connector to the BNC connector on the DECserver
90L+. Make sure the Ethernet segment is properly terminated at each end.
3.
Attach the power cord to the power supply, if needed.
4.
Plug the power supply into a working AC outlet.
5.
The following indicators should be lit: power, self-test ok, and network.
Within five seconds, the self-test ok indicator should be lit, followed by the
network indicator.
Verify Ports.
Verify the operation of each port by connecting a terminal to the port. Refer to
Table 1–1 for supported terminal characteristics. Press
Return
twice (autobaud)
to set the operating speed of the port. While watching the Activity LED, type a
character on the terminal. The LED should turn on and off, indicating activity on
the port. Perform this procedure for each port.
Verify Network.
Verify the operation of the network. Enter SHOW S at the prompt (->) and press
Return
. The server characteristics screen will verify if the network is "OK" or
"Failed". If "Failed", make sure the server is on a properly configured network.
For more information on the SHOW S command, refer to Chapter 4.
2–4 Installing the DECserver 90L+
