Installing the DECserver 90L+
Start Terminal Session.
1.
Connect terminals to ports as needed.
2.
To start a terminal session using a terminal connected to one of the ports:
a.
With the terminal turned on, press
Return
twice. This sets the baud rate
of the port to that of the terminal.
b.
At the prompt (->), enter a service name and press
Return
.
The DECserver 90L+ responds by displaying a string of dots "......" while
connecting to the selected service. Once the connection is established,
your terminal will display the system-dependent login message or prompt.
Note
The DECserver 90L+ can take up to one minute when connecting to a
node for the first time.
For more information on using the DECserver 90L+, refer to Chapter 3 in this
manual.
Backplane Installation
To install the DECserver 90L+ in the DEChub 90 Ethernet backplane, perform
the following procedures and refer to Figure 2–3.
Remove Cover (if necessary).
If the unit to be installed in the backplane has a cover on the back of the unit,
remove the cover (Figure 2–2).
To remove the back cover on the DECserver 90L+ unit:
1.
Insert a small screwdriver into the top mounting hole in the cover.
2.
Lift up on the latch.
3.
While lifting up on the latch, pull the top of the cover away and down from
the unit.
Installing the DECserver 90L+ 2–5
