Managing the DECserver 90L+
Management Commands
The commands used to manage the DECserver 90L+ are the SET, SHOW, and
RESET commands. The SET and SHOW commands can be used from the menu
to show or set parameters. A command line mode is available for use by network
management software or by users that want to bypass the menu interface.
Refer to the Command Line section at the end of this chapter, for more detailed
information on command line mode.
The following sections show how to enter the SET, SHOW, and RESET commands
using the menu and the command line.
SET Command
The SET command allows you to set port or server parameters, zero network
counters, and enable and use the DECserver 90L+ security features.
Setting Port Parameters
The following port parameters can be set for each port:
•
Port name
•
Port speed (baud rate)
•
Input flow control
•
Output flow control
•
Device type (terminal or printer)
•
Local or remote break
•
Remote modify
•
Test (loopback) operation
Table 4–3 describes each of the port parameters that can be set.
Port parameters can be set from the menu or by a command line entered at the
prompt. If authorized mode is set and the port parameters to be set are for a
port other than the one you are connected to, then you must first enable manager
mode.
4–6 Managing the DECserver 90L+