Operating the DECserver 90L+
Resuming an Interrupted Terminal Session
To resume the current interrupted terminal session, type the connect command
>
or RESU[ME] at the DECserver 90L+ prompt. To resume a specific session,
type the command and specify the session number. In the case of a MOP session,
type M in place of the session number. The following is an example of resuming
terminal session 2 for a port.
-> > 2
Return
-> %DS90L-112, YELLOW session 2 resumed
When you resume an interrupted session, control is returned to the point at
which the session was interrupted.
Cycle Forward from an Interrupted Terminal Session
After you interrupt a terminal session, you can cycle forward to the next session.
This is done by entering the FORWARD command F[ORWARD] at the DECserver
90L+ prompt and pressing
Return
. The following is an example of having
interrupted session 2 and forwarding to session 3.
-> F
Return
-> %DS90L-112, GREEN session 3 resumed
Cycle Backward from an Interrupted Terminal Session
After you interrupt a terminal session, you can cycle backward to the session
previous to the session that was interrupted. This is done by entering the
BACKWARD command B[ACKWARD] at the DECserver 90L+ prompt and
pressing
Return
. The following is an example of having interrupted session 2 and
cycling backward to session 1.
-> B
Return
-> %DS90L-112, RED session 1 resumed
Note
There are no definable switch characters to immediately go forward and
backward between sessions as in other Digital terminal servers.
The FORWARD and BACKWARD commands are circular, that is they
"loop" or "cycle" through the number of sessions established.
Operating the DECserver 90L+ 3–5
