DG Flugzeugbau DG-800A, Руководство по обслуживанию, Страница: 92 / 163

Maintenance Manual DG-808C
Issued: May 2012 TN 800/41 4.31
4.18 Removal and assembly of the engine doors
It is not necessary to cut the rubber cords for removal and assembly of the
engine doors.
a) Removal of the left engine door, e.g. for working at the carburettor: Extend
the engine. Remove the helical spring from the left engine door by stretching
the spring using small pliers. Unhook the spring. Pull the spring pins out of
the hinge pins. Remove the hinge pins. Retract the engine until just before
the engine doors close. Move the left engine door far enough backwards, so
that you can lift the rear rubber cord on top of the propeller. Lift the engine
door and lay it down on the right engine door.
b) Removal of both engine doors: Disassemble springs and hinge pins of both
engine doors. Retract the engine ¾ of it´s travel and lift both doors away.
c) Assembly is the reverse of disassembly. Use new selflocking nuts.