DG Flugzeugbau DG-800A, Руководство по обслуживанию, Страница: 20 / 163

Maintenance Manual DG-808C
Issued: June 2005 1.7
1.4.5 Complete readjustment
Should it be necessary to completely reset the flap and aileron control, proceed
as follows:
Place the fuselage with the centre line horizontal see sect. 1.1. Fix the mixer
shaft 8St70 (see diagram 3) in horizontal position.
then:
1. Adjust the control stick to neutral.
2. Adjust the wing flap handle to 0° flapsetting.
3. Adjust the flaperons: + 10.6 mm (0.42 in.) measured against the fixed part at
the wing root and + 4.1 mm (0.16 in.) against the 18 m wing tip.
To adjust the flaperons you must first remove the fairings from the control
surface horns. Then unscrew the horns (Allen key wrench) and loosen the lock
nut (12 mm open ended wrench) at the rod ends. Adjustment is made by rotating
the complete drive.
Caution: Secure the bolts again with a small amount of Loctite 243.
4. Adjust the aileron stops. (See 1.4.3)
5. Check the flap deflections and adjust the stops if necessary. (See 1.4.3)
6. Glue the fairings to the control surface horns with Polyester resin. Apply
pressure when gluing to prevent the fairings interfering.
horizontal
8St70