DG Flugzeugbau DG-800A, Руководство по обслуживанию, Страница: 152 / 163

Enclosure 1 for maintenance manual
Issued: June 2005 page 1 from 3
Instruction for downloading log book and service data from the DEI-NT
1) Hardware requirements: - serial data cable (zero modem cable, 9 pin)
- pc with terminal program (e.g. hyperterminal)
2) Transfer of data from DEI-NT to PC (Example for Windows /
hyperterminal):
a) switch off PC and glider master switch
b) connect zero modem cable
c) switch on PC
d) start hyperterminal (click on START, then ACCESSORIES, then
COMMUNICATIONS, then HYPERTERMINAL), select new
connection, enter name e.g. “DEI-LOG”, select Symbol, click ok
e) in the next window, select appropriated COM – port (e.g. COM1 or
direct connection COM1)
f) select config and configure the serial data:
−
9600 baud
−
8 data bits
−
parity no
−
1 stop bit
−
flow control: XON/XOFF or none
g) save changes “File/Save”
h) select “transfer/capture text”
i) enter a new filename. Attention: if you use an existing file, all data
will be appended to this file!
j) click start. Hyperterminal is now ready to receive
k) Switch on glider master switch. The DEI-NT starts up with the
opening display
l) And changes after 3 – 5 seconds to the flight display. Push the
selector knob, until the DEI-NT beeps twice and the screen
changes.
The following screens will appear in this order:
flight screen
Æ Flight log screen Æ Setup Screen Æ Operation
time screen Æ flight screen …
Change to setup-screen:
m) by rotating the selector knob select FLIGHTLOG
Æ
PC
n) push selector knob briefly. N appears on the screen.
o) rotate mode button until Y appears