DG Flugzeugbau DG-800A, Руководство по обслуживанию, Страница: 18 / 163

Maintenance Manual DG-808C
Issued: May 2012 TN800/41 1.5
1.3 Rudder control
1.3.1 Rudder control circuit
see diagram 2
1.3.2 Rudder deflections and tolerances
155mm (6.5 inch) (28°) +0, -5mm (-.2 inch) measured at 318 mm (12.52 inch)
from the hinge axis.
1.3.3 Rudder stops
The rudder stops are located at the lower hinge pedestal and can be adjusted
with an Allen key wrench.
1.3.4 Axial free Play
The maximum allowable free play at the upper hinge point is 1.5 mm (0.06 inch)
1.3.5 Sealing the rudder
The rudder is sealed on both sides. On the outside with Mylar combi-tape and
inside the fin with V-sealing tapes
These sealings are not to be removed.
If damaged it should be replaced, see section 4.7.6
1.3.6 Retaining spring for the pedal adjustment handle
A spring which pulls the pedal adjustment cable tight is installed in the console
below the instrument panel. If this spring is defective or not connected the
handle of the pedal adjustment cable won’t be pulled to the front so that it may
hook into the trim release lever at the control stick with pedals in a rear position.
max. 1,5 mm