Dell XPS M2010, Руководство по обслуживанию

Страница: 81 / 131

Removing the Processor
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Disconnect the power cables from the POWER1 and POWER2 connectors (see System Board Components ) on the system board.
4. Remove the airflow shroud (see Removing the Processor Airflow Shroud ).
5. Push down and out on the socket release lever.
6. Lift the socket release lever and open the processor cover.
7. Remove the processor from the socket.
Leave the release lever extended in the release position so that the socket is ready for the processor to be replaced.
Installing the Processor
1. If the release lever on the socket is not fully extended, move it to that position.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide .
NOTICE: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could
damage your system board. For technical service, see "Dell Technical Support Policy (U.S. Only)" in your Owner's Manual .
1 processor cover 2 processor 3 socket
4 socket release lever
NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.
NOTICE: You must position the processor correctly in the socket to avoid permanent damage to the processor and the computer when you turn on the
computer.
2. Align the pin-1 corner of the processor and socket.