Dell XPS M2010, Руководство по обслуживанию

Страница: 50 / 131

Replacing the Memory Module
1. Align the notch on the edge of the memory module connector with the tab in the connector on the system board, and slide the module firmly into the
connector at a 45-degree angle.
2. Rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.
3. Replace the memory cover. Align the notches in the cover with the tabs on the base, slide the cover toward the front of the computer, and tighten the
captive screw.
4. Replace the system battery (see Replacing the System Battery ).
5. Turn the computer over and open the display (see Opening the Display ).
6. Press the power button to turn the computer on.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
To confirm the amount of memory installed in the computer, click the Start button, click Help and Support , and then click Computer Information .
Back to Contents Page
1 securing clips (2 per connector) 2 memory modules (2) 3 system board connectors (2)
NOTICE: Insert memory modules at a 45-degree angle to avoid damaging the connector.
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and
the modules must be of the same size and configuration.
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.