Maintenance kit very low, [x] estimated pages remain [80.xy]
You may need to replace the maintenance kit very soon. For more information, contact technical support
or your Dell printer dealer.
If necessary, touch
Continue
to clear the message and continue printing.
Memory full [38]
Try one or more of the following:
•
From the printer control panel, touch
Cancel job
to clear the message.
•
Install additional printer memory.
Network [x] software error [54]
Try one or more of the following:
•
From the printer control panel, touch
Continue
to continue printing.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or print server. For more information, contact technical
support or your Dell printer dealer.
Non
‑
Dell [supply type], see User’s Guide [33.xy]
Note:
The supply type can either be a toner cartridge or imaging unit.
The printer has detected a non
‑
Dell supply or part installed in the printer.
Your Dell printer is designed to function best with genuine Dell supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Dell supplies and parts, and may deliver unpredictable results
if third-party supplies or parts are used. Imaging component usage beyond the intended life may damage
your Dell printer or associated components.
Warning—Potential Damage:
Use of third-party supplies or parts can affect warranty coverage.
Damage caused by the use of third-party supplies or parts are not covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your
printer, press and hold
and
#
on the printer control panel simultaneously for 15 seconds to clear the
message and continue printing.
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and
then install a genuine Dell supply or part.
Note:
For the list of supported supplies, see the “Ordering supplies” section of the
User's Guide
or visit
.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
•
From the printer control panel, touch
Continue
to clear the message and continue printing.
•
Delete fonts, macros, and other data stored in the flash memory.
Troubleshooting
180
Содержание S5830DN
Страница 164: ...4 Reload paper and then adjust the paper guide 5 From the home screen touch Clearing jams 164 ...
Страница 165: ...Staple jam in the finisher 1 Open the staple access door 2 Remove the staple cartridge holder Clearing jams 165 ...
Страница 166: ...3 Open the staple guard and then remove the loose staples 4 Close the staple guard Clearing jams 166 ...
